EPOXY  
EPIWELD® 300

2 component, pre-measured auto-mix cartridges of 100% epoxy gel. The product dispenses from each chamber at a 1:1 ratio.

Now available in two handy sizes:
SINGLES.  This 8.6 fl. oz. (254.3 ml) auto-mix dual chamber vertical cartridge unit can be used  in any standard caulking gun.  Each cartridge comes packaged with a 2-piece nozzle.  Instruction for use.
Packaging: Case lots only.  20 cartridges per case.


ORIGINAL.  22 fl. oz. (650 ml) unit has two side by side auto-mix dual cartridges, for use in the Epiweld Dispensing Gun, shown below. Specially designed mixing nozzles are sold separately.
Packaging: Case lots only.  12 cartridge sets per case.



ASTM C-881, Type I, II, V, Grade 3, Class B&C
Florida D.O.T., Section 926, category A106
Georgia D.O.T., Section 886, Type III
ICC and ICBO requirements also met
On FDOT QPL section 937:  #: S937-0106

 Acrobat 5 or higher is required for viewing - approx 30 secs to load.
 Earlier versions of the reader will not work.




Product list by Type | F.A.Q | Contact Lambert | Resource Center | Prosoco Products | Curbing |
©2001-2010 Lambert Corporation - Orlando, Florida - All rights reserved